Hyundai Tucson manuels

Hyundai Santa Cruz 2021-2022 Owners Manual: Windshield Wipers

Operates as follows when the ignition switch is turned ON.

MIST : For a single wiping cycle, move the lever up and release it. The wipers will operate continuously if the lever is held in this position.

OFF : Wipers are not in operation.

INT : Wipers operate intermittently at the same wiping intervals. Use this mode in light rain or mist. To vary the speed setting, turn the speed control knob.

LO : The wiper runs at a lower speed.

HI : The wiper runs at a higher speed.

Information

If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.

If you do not remove the snow and/or ice before using the wiper and washer, it may damage the wiper and washer system.

AUTO Wiper Control

The rain sensor located on the upper end of the windshield glass senses the amount of rainfall and controls the wiping cycle for the proper interval. The wiper operation time will be automatically controlled depends on rainfall.

When the rain stops, the wiper stops. To vary the sensitivity setting, turn the sensitivity control knob.

If the wiper switch is set in AUTO mode when the ignition switch is in the ON position, the wiper will operate once to perform a self-check of the system. Set the wiper to the OFF position when the wiper is not in use.

WARNING

To avoid personal injury from the windshield wipers, when the engine is running and the windshield wiper switch is placed in the AUTO mode:

NOTICE

Wipers and Washers
A. Wiper speed control MIST – Single wipe OFF – Off INT – Intermittent wipe AUTO – Auto control wipe (if equipped) LO– Low wiper speed HI – High wiper speed B. Intermittent cont ...

Windshield Washers
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. The spray and wiper operation will continue until you release the l ...

Autres materiaux:

Préservation de la brillance du métal
Pour éliminer le goudron et les insectes, utilisez un anti-goudron et non un grattoir ou un autre objet pointu. Pour protéger les surfaces des pièces en métal brillant contre la corrosion, appliquez une couche de cire ou de produit de protection des chromes et frottez pour obtenir ...

Composants et emplacement des composants
Emplacement des composants (1) 1. Boîte de vitesses automatique 2. Capteur de vitesse de sortie 3. Capteur de vitesse d’entrée 4. Connecteur de l'électrovanne 5. Capteur de température d'huile 6. Support de fixation de l'électrovanne ...

© 2016-2022 Kopyright www.htumanuel.com