Hyundai Tucson manuels

Hyundai Santa Cruz 2021-2022 Owners Manual: Towing

Towing Service

[A] : Dollies

If emergency towing is necessary, we recommend having it done by an authorized HYUNDAI dealer or a commercial tow-truck service.

Proper lifting and towing procedures are necessary to prevent damage to the vehicle. The use of wheel dollies or flatbed is recommended.

For FWD vehicles, it is acceptable to tow the vehicle using a tow truck as long as the front wheels (which are the drive wheels) are off the ground. The rear wheels can be on the ground without the use of dollies.

For AWD vehicles, all wheels must be off the ground. Therefore, a flat bed trailer is recommended.

If any of the loaded wheels or suspension components are damaged or the vehicle is being towed with the rear wheels on the ground, use a towing dolly under the rear wheels.

When being towed by a commercial tow truck and wheel dollies are not used, the front of the vehicle should always be lifted, not the rear.

For AWD vehicles, it must be towed with a wheel lift and dollies or flatbed equipment with all the wheels off the ground.

NOTICE

Do not lift the vehicle by the tow fitting or body and chassis parts. Otherwise the vehicle may be damaged.

CAUTION

• Do not tow the vehicle with the front wheels on the ground as this may cause damage to the vehicle.

• Do not tow with sling-type equipment. Use wheel lift or flatbed equipment.

When towing your vehicle in an emergency without wheel dollies:

1. Release EPB before turning off the engine.

2. Place the ignition switch to the OFF position.

3. Change the gear to N (Neutral) while pressing the brake pedal.

4. Place the ignition switch to the ACC position.

CAUTION

Failure to shift the gear to N (Neutral) may cause internal damage to the transmission.

Jack Label
The actual Jack label in the vehicle may differ from the illustration. For more detailed specifications, refer to the label attached to the jack. 1. Model Name 2. Maximum allowable load 3. When usin ...

Maintenance
...

Autres materiaux:

Stationnement
Attendez d'être bien arrêté et continuez à appuyer sur la pédale de frein. Placez le levier de vitesses en position P (Parking), enclenchez le frein de stationnement et mettez le contact en position LOCK/OFF. Prenez la clé avec vous lorsque vous quittez le véhicule. AVERTISSEMENT ...

Rhéostat
Composants et emplacement des composants COMPOSANTS Procédures de réparation Contrôle 1. Débranchez la borne négative (-) de la batterie. 2. Retirez le commutateur de l'absorbeur de chocs inférieur (A) après a ...

© 2016-2022 Kopyright www.htumanuel.com