Hyundai Tucson manuels

Hyundai Santa Cruz 2021-2022 Owners Manual: Locking your vehicle (Touch sensor type)

1. Make sure that all doors are closed.

2. While having the Smart Key in your possession, touch the outer part of the door handle on or near the handle detent for about 1 second or until you hear the door locks actuate.

3. The doors will be locked. If the tailgate was open, then when the tailgate is closed it will be locked also.

The chime will sound once and the hazard warning lights will blink.

Note that if you press the outside door handle to lock the doors using the touch sensor, the doors will not lock under the following circumstances:

If this occurs, then a chime will sound for about 3 seconds. Check the vehicle before attempting to lock the car again.


Before you leave your vehicle with the Smart Key, verify that your vehicle is locked. When using the touch sensor on the front door handle, listen to hear that the lock has actuated, and then pull the handle within 3 seconds to confirm the doors are locked.

(if it has been longer than 3 seconds, verify the doors are locked by pressing the lock button on the Smart Key. You will hear a single beep.)


Do not leave the Smart Key in your vehicle with children that are unattended or unsupervised.

Children could inadvertently press the Engine Start/Stop button or could operate the power windows or other vehicle controls or even cause the vehicle to move. This could result in serious injury or death.

Locking your vehicle (Button type)
To lock : 1. Close all doors, engine hood and tailgate. 2. Carry the smart key. 3. Either press the door handle button or press the Door Lock button (1) on the smart key. 4. The hazard warning lig ...

Unlocking your vehicle(When the Two Press Unlock feature is off)
1. Make sure you have the smart key in your possession. 2. Press the Door Unlock button (2) on the smart key, press the button on the front door handle or touch the door unlock sensor inside of t ...

Autres materiaux:

Fermeture de porte avant
Composants et emplacement des composants EMPLACEMENT DES COMPOSANTS 1. Serrure de porte avant Procédures de réparation REMPLACEMENT 1. Enlevez le module de porte avant. (Reportez-vous à Porte avant - " ...

Description et fonctionnement
DESCRIPTION GÉNÉRALE zDE L′INSTALLATION RPAS (Système d'aide au stationnement) est un dispositif d'aide électronique avertissant le conducteur à être attentif pendant le stationnement ou la conduite à faible vitesse. Le capteur utilise des ondes ultrasonore ...

© 2016-2022 Kopyright